Does any one know which of the many posts that BobCAD/Cam has is best?
Does any one from Denford Support have an idea how I might know, is there a spec I could use.
VR Milling VR Turning using BobCad which Post to use
Moderators: Martin, Steve, Mr Magoo
VR Milling VR Turning using BobCad which Post to use
I am considering using BobCAD with VR Milling 2.3 and VR Turning
Does any one know which of the many posts that BobCAD/Cam has is best?
Does any one from Denford Support have an idea how I might know, is there a spec I could use.
Does any one know which of the many posts that BobCAD/Cam has is best?
Does any one from Denford Support have an idea how I might know, is there a spec I could use.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: VR Milling VR Turning using BobCad which Post to use
Have locked this as I feel it should belong in the post section:
viewtopic.php?f=16&t=3613
viewtopic.php?f=16&t=3613