NOVATURN TOOL CHANGE POSITION.

[Dodds]

Hi, would anyone know if it is possible to alter the tool change position on my Novaturn. (in a program)
Using M6 It currently rapids to the home position to change a tool (Auto tool changer!) This wastes time and adds extra wear to the machine and so I was wondering if I can insert/alter the code so that it retracts only the amount necessary to safely change a tool rather than retracting all the way to home each time.

Any suggestions welcome

Cheers
David

[Martin]

Hi David

What software are you using to run the Novaturn?

[Dodds]

Hi Martin, thank you for your reply and sorry for the delay in getting back to you.
The control software is VR CNC Turning V1.49.

For programs I have a copy of edgecam and use a post that's close and just edit it a little.

Cheers
David

[Martin]

If you go to Setup then to Machine Parameters & enter the password denny you can change it in the Tool Changer box.

[Dodds]

Thank you Martin, that worked fine.

Cheers
David