Novamill tool-changer interface
Posted: Sat 29 Oct , 2016 19:20 pm
Hi Folks,
I'm running a Novamill with Win 2K VR Milling v2.32, and I'm designing a DIY toolchanger.
Is there any details availble on how VR Milling v2.32 and the control box communicate with to a toolchanger? Obviously the hardware is only half of the solution, it needs to talk to the controller too.
As always any help would be much appreciated.
Cheers
BPM
I'm running a Novamill with Win 2K VR Milling v2.32, and I'm designing a DIY toolchanger.
Is there any details availble on how VR Milling v2.32 and the control box communicate with to a toolchanger? Obviously the hardware is only half of the solution, it needs to talk to the controller too.
As always any help would be much appreciated.
Cheers
BPM