Converting a Novamill to Mac3
Posted: Sun 23 Nov , 2014 20:57 pm
Hi ,
Have purchased a novamill and wanting to change it to run on Mach3
Looking through the forum I have found a post by Alastair : Bringing my novamill back to life.
I have a few questions on this and wonderd if anyone can help
1 Is there a data sheet which will tell me what each pin of the 96 way connector on the denstep control board does.In the picture that Alastair posted the pulse and limit wires are obvious but I am confussed on what the Brown and Grey/Black does.
Thanks
Dave
Have purchased a novamill and wanting to change it to run on Mach3
Looking through the forum I have found a post by Alastair : Bringing my novamill back to life.
I have a few questions on this and wonderd if anyone can help
1 Is there a data sheet which will tell me what each pin of the 96 way connector on the denstep control board does.In the picture that Alastair posted the pulse and limit wires are obvious but I am confussed on what the Brown and Grey/Black does.
Thanks
Dave