Page 1 of 1
Easy Change tool holders
Posted: Tue 06 Dec , 2011 23:48 pm
by JohnHaine
Does anyone have dimensioned drawings for the spindle fitting end of Easy Change toolholders please?
John.
Re: Easy Change tool holders
Posted: Thu 22 Dec , 2011 14:35 pm
by Steve
Re: Easy Change tool holders
Posted: Thu 22 Dec , 2011 16:09 pm
by JohnHaine
Thanks - as they don't give dimensions they are obviously potentially easy to make!
Re: Easy Change tool holders
Posted: Thu 22 Dec , 2011 19:01 pm
by angel-tech
the critical dimensions are going to be the taper diameter and the rear face of the groove.
Re: Easy Change tool holders
Posted: Fri 30 Dec , 2011 12:18 pm
by y_shalom
Re: Easy Change tool holders
Posted: Fri 30 Dec , 2011 14:10 pm
by JohnHaine
That looks like the one! Well spotted, and thanks. John.
Re: Easy Change tool holders
Posted: Fri 30 Dec , 2011 14:27 pm
by angel-tech
really usefull, thanks
Re: Easy Change tool holders
Posted: Fri 30 Dec , 2011 22:46 pm
by flyingmike
You can buy these from J&L if you get stuck and if you look out for the discounts you can save a few bob. I think the easy change system is great but takes up a lot of room on an already limited head height machine. hence why I raised the column. There are some nice ISO30 collet holders about though.