Novamill
Posted: Sat 01 Dec , 2007 16:12 pm
Hi,
I'm new to this forum but noticed that some of you are using Mach3 software to control your Denford machines. My Novamill is now up and running and I did a short video on Youtube :-
https://www.youtube.com/watch?v=GMSKSDKfB3g
Not had a lot of time to play yet but it is looking useful. The front panel on my control box was engraved using the write wizard in Mach3 - see attached photo.
Ian
I'm new to this forum but noticed that some of you are using Mach3 software to control your Denford machines. My Novamill is now up and running and I did a short video on Youtube :-
https://www.youtube.com/watch?v=GMSKSDKfB3g
Not had a lot of time to play yet but it is looking useful. The front panel on my control box was engraved using the write wizard in Mach3 - see attached photo.
Ian