I've been asked to help with the conversion of a Mirac which seems to be in good condition, but has no software or dongle for the PC. A quick review seems to indicate that providing a new breakout board for Mach3 or USBCNC should not be difficult, but the set-up does not match any of the circuit diagrams I've seen so far. http://medw.co.uk/fisheye/gallery/148 has some pictures showing 2 off the KEB-F0 inverters in the bottom of the cabinet.
Anybody seen/got one of this version of build? Or some appropriate drawings?
( I've an Orac almost ready to go home, and a sick Easyturn which needs it's tacho pickup sorting out as well )
Mirac Conversion
Moderators: Martin, Steve, Mr Magoo
- lsces
- Posts: 1
- Joined: Fri 07 Dec , 2012 21:57 pm
- Hardware/Software: Mach3 and USBCNC into various machines
Orac
Mirac
Easyturn
and others including the Taig Micromill - Location: Broadway, UK
- Contact:
Mirac Conversion
Lester Caine - G8HFL
-----------------------------
Contact - http://lsces.co.uk/wiki/contact
Model Engineers Digital Workshop - http://medw.co.uk
-----------------------------
Contact - http://lsces.co.uk/wiki/contact
Model Engineers Digital Workshop - http://medw.co.uk
-
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: Mirac Conversion
give me a ring on 07791011037
Tom.
Tom.
- Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Mirac Conversion
These drawings look close:
viewtopic.php?f=40&t=630
viewtopic.php?f=40&t=630