Page 1 of 1
Mirac PC (LCB3 ) Upgrade
Posted: Wed 19 Nov , 2008 18:26 pm
by boots
We have Mirac PC with controller s/n E03953, dispatch 7/1991 and want to upgrade from DOS to Windows VR Turning software.
The control card does not look close to any of the images you provided. It’s kind of an L-shaped board marked LCB3.
Any thoughts?
Posted: Wed 19 Nov , 2008 18:38 pm
by boots
Here are some photos:
Posted: Wed 19 Nov , 2008 19:42 pm
by boots
Info on the IC that is circled:
Here's what's on the EPROM:
EPROM NO 929
PC03095 LCB3
SKT V5 R1.1
The V in V5 might be a U.
Posted: Thu 20 Nov , 2008 8:49 am
by bradders
Unfortunately the LCB3 controls were supplied by a comapany called GSM in Huddersfield West Yorkshire, they are now out of business so upgrades from Denford's cannot be offered.
People with these machines seem to go the Mach 3 route
Posted: Thu 20 Nov , 2008 14:42 pm
by boots
Mach 3 route????
Posted: Thu 20 Nov , 2008 14:50 pm
by bradders
Boots,
Check out the Mach3 site
https://www.machsupport.com/
Also I think there lots of posts on the forum regarding Mach3
Posted: Thu 20 Nov , 2008 16:05 pm
by boots
Thank You