All info relating to the Denford Mirac lathes
Moderators: Martin, Steve, Mr Magoo
-
boots
- CNC Expert
- Posts: 220
- Joined: Tue 16 Jan , 2007 21:22 pm
Post
by boots » Wed 19 Nov , 2008 18:26 pm
We have Mirac PC with controller s/n E03953, dispatch 7/1991 and want to upgrade from DOS to Windows VR Turning software.
The control card does not look close to any of the images you provided. It’s kind of an L-shaped board marked LCB3.
Any thoughts?
-
boots
- CNC Expert
- Posts: 220
- Joined: Tue 16 Jan , 2007 21:22 pm
Post
by boots » Wed 19 Nov , 2008 19:42 pm
Info on the IC that is circled:
Here's what's on the EPROM:
EPROM NO 929
PC03095 LCB3
SKT V5 R1.1
The V in V5 might be a U.
-
Attachments
-
- IMAGE_011circle.png (5.53 MiB) Viewed 6038 times
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
-
Contact:
Post
by bradders » Thu 20 Nov , 2008 8:49 am
Unfortunately the LCB3 controls were supplied by a comapany called GSM in Huddersfield West Yorkshire, they are now out of business so upgrades from Denford's cannot be offered.
People with these machines seem to go the Mach 3 route
-
boots
- CNC Expert
- Posts: 220
- Joined: Tue 16 Jan , 2007 21:22 pm
Post
by boots » Thu 20 Nov , 2008 14:42 pm
Mach 3 route????
-
bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
-
Contact:
Post
by bradders » Thu 20 Nov , 2008 14:50 pm
Boots,
Check out the Mach3 site
http://www.machsupport.com/
Also I think there lots of posts on the forum regarding Mach3
-
boots
- CNC Expert
- Posts: 220
- Joined: Tue 16 Jan , 2007 21:22 pm
Post
by boots » Thu 20 Nov , 2008 16:05 pm
Thank You
