Can I run a cyclone using a slave motor and converter on 240?

General support, help and advice for Denford CNC machines (old and new)

Moderators: Martin, Steve, Mr Magoo

Post Reply
Tokomo123
Posts: 2
Joined: Wed 29 Jun , 2022 16:27 pm
Hardware/Software: Denford cyclone Fanuc

Can I run a cyclone using a slave motor and converter on 240?

Post by Tokomo123 » Wed 29 Jun , 2022 17:46 pm

Hi I’m a real newbie to CnC and have bought a Cyclone with Fanuc controls, I didn’t realise before buying it that there were issues running CNC machines without proper three phase, and seem to have stumbled into a mine field 🤪

Has anyone tried running one with a digital converter with a slave motor wired into the circuit to even out the phases?

Thanks in advance for any help!

Post Reply