Hi,
I have a laptop which I want to connect to my Orac from 1983 for making/storing programs.
The laptop has only USB-ports and the Orac has seriel RS232 (?) port.
Is it possible to use a converter between the PC and Orac for for transferring data?
(In both directions)
Any suggestions for brand/type? Experiance?
Thanks for any hints.
CNC Guru
Its all a bit hit and miss
We have found some work and others do not.
Any brand we would have tested will probably be obsolete. I am sure there is an artical on the forum about a recomended converter.
I think you just have to get one and try it out
Good Luck!
We have found some work and others do not.
Any brand we would have tested will probably be obsolete. I am sure there is an artical on the forum about a recomended converter.
I think you just have to get one and try it out
Good Luck!
Site Admin
Some previous discussion on USB>Rs232 devices:
viewtopic.php?f=4&t=1750&hilit=usb+rs232
viewtopic.php?f=4&t=2043&hilit=usb+rs232
viewtopic.php?f=4&t=1750&hilit=usb+rs232
viewtopic.php?f=4&t=2043&hilit=usb+rs232