Running Windows XP and VR CNC Milling 2.28 This is the first problem with the machine. Any suggestions on what the problem might be? I have re-installed the software with the same results. I have also installed on another computer with same results.
Manual feed has been set to max with no effect.
Microrouter will home but will not jog
Moderators: Martin, Steve, Mr Magoo
-
Secrest
- Posts: 1
- Joined: Fri 13 Jan , 2012 16:32 pm
- Hardware/Software: Microrouter Compact/VR CNC Milling ver. 2.28
Microrouter will home but will not jog
Last edited by Secrest on Fri 13 Jan , 2012 16:58 pm, edited 1 time in total.
Re: Microrouter will home but will not jog
Check that the feed overide button is not on 0%.
- Attachments
-
- screen1.jpg (28.84 KiB) Viewed 13729 times
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Microrouter will home but will not jog
It's also worth checking the jog keys definitions haven't been tampered with:
viewtopic.php?f=8&t=729
viewtopic.php?f=8&t=729