Microrouter Spindle motor takes time to run up to speed

All info relating to the Denford MicroRouter and MicroRouter Pro CNC Routers

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Microrouter Spindle motor takes time to run up to speed

Post by bradders » Wed 18 Apr , 2007 10:51 am

My Microrouter Spindle motor takes time to run up to speed
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Wed 18 Apr , 2007 11:30 am

This sounds like an Analogue problem from the Baldor axis drive card

Terminals

SPINDLE and S-GROUND (Bottom LHS of board)
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Wed 18 Apr , 2007 14:35 pm

If you have a spindle control card, it could also be this that is faulty.

Or maybe the motor brushes need replacing ?
Top
Post Reply

Return to “MicroRouter”