TechTurn

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
dthatcher7
Posts: 2
Joined: Fri 17 Mar , 2023 19:26 pm

TechTurn

Post by dthatcher7 » Mon 20 Mar , 2023 18:28 pm

Greetings,

I have a Brodhead-Garrett TechTurn machine (see attached pic) with the esMINT/3.28 v1.6h/S-JD5 chip.
I am an IT guy with no experience running these machines but I am trying to get it working for the department that wants to use it.
I am going to connect the machine to a PC running a DOS VM with the proper software, then hand over to the department in question to actually use.
I am not sure which programs from the following page I need to download:
https://denford.co.uk/dos-vintage-machine-information/
I have looked at other posts on the forum and I think I at least need one of the Fanuc* programs.

Any help is appreciated.
Attachments
PXL_20230316_163701727.jpg
PXL_20230316_163701727.jpg (275.22 KiB) Viewed 3768 times

Martin
CNC Guru
CNC Guru
Posts: 1896
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: TechTurn

Post by Martin » Wed 22 Mar , 2023 13:58 pm

Have you got the machine serial number?

dthatcher7
Posts: 2
Joined: Fri 17 Mar , 2023 19:26 pm

Re: TechTurn

Post by dthatcher7 » Thu 23 Mar , 2023 16:07 pm

I have looked around the machine and cannot locate a serial number.

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1430
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: TechTurn

Post by Steve » Thu 23 Mar , 2023 17:06 pm

Possibly an American made machine.

Post Reply