Puling 12v/5v off Micromill/Microturn
Posted: Sat 08 May , 2021 18:49 pm
I'm in the process of converting a micromil/microturn to Mach3
The conversion is all good but sadly the Breakout board requires two power sources a 5V and a 12v supply.
Anyone got a good way of going about this?
I've got the original Baldor board still in there and I'm driving everything off the pins.
To be honest I've seen I can get 5v off A1/A3 but wasn't too sure if also attempting to pull 12v off the Baldor board would be safe too?
Any suggestions would be appreciated!
The conversion is all good but sadly the Breakout board requires two power sources a 5V and a 12v supply.
Anyone got a good way of going about this?
I've got the original Baldor board still in there and I'm driving everything off the pins.
To be honest I've seen I can get 5v off A1/A3 but wasn't too sure if also attempting to pull 12v off the Baldor board would be safe too?
Any suggestions would be appreciated!