Tech Design / Micromill

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
bob11x
Posts: 5
Joined: Tue 04 Feb , 2014 18:01 pm
Hardware/Software: Tech Design CNC Mill SP40703A Electronics #OC00134827

Tech Design / Micromill

Post by bob11x » Sat 08 Feb , 2014 3:58 am

After posting the following in the wrong board someone kindly pointed me here and this is the machine I have. It is a 1996 - the schematics I see here seem to be 2000 and up. Any info on this old machine would be appreciated as I have zero knowledge of these.

I acquired a Tech Design by Lab Volt CNC Mill. Tag says:

Tech Design
Machine S/N: SP40703A
Electronics S/N: OC00134827
Nov 1996

I have a machine that the cords have been cut and I have no paperwork. Any info available? Wiring Diagrams? Software ? Hardware differences to look for? Conversion possibilities?

Any help or suggestions would be greatly appreciated.

Thank you.

bob

bob11x
Posts: 5
Joined: Tue 04 Feb , 2014 18:01 pm
Hardware/Software: Tech Design CNC Mill SP40703A Electronics #OC00134827

Re: Tech Design / Micromill

Post by bob11x » Wed 19 Mar , 2014 0:07 am

Finally had a chance to read a little on this unit. Not up to speed yet. SO it looks like I have an antique. EPROM esMINT/3.28 v1.6h/S-JD5

I have no software for it. What will it take to run it - I am assuming all electrical is ok.

Not being up to speed I will ask another question - is it possible to use a generic control setup? Anyone done this? Any site anyone could point me to?
The machine is like new - hate to scrap it....

bob11x
Posts: 5
Joined: Tue 04 Feb , 2014 18:01 pm
Hardware/Software: Tech Design CNC Mill SP40703A Electronics #OC00134827

Re: Tech Design / Micromill

Post by bob11x » Tue 09 Dec , 2014 17:51 pm

Wow - been 9 months and no replies? Just got time to delving into it and thought someone may have some ideas by now....

Seems like someone would have converted this unit before - looks like a tiny G board may work. Will let you know.

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Tech Design / Micromill

Post by Martin » Tue 09 Dec , 2014 19:20 pm

You should be able to download the original software from the Denford website,

http://website.denford.ltd.uk/support/9 ... s-software

You will need a computer with a Com port to run it.

Post Reply