Denford Software & Machines

Posted: **Fri 31 May , 2013 4:27 am**

I happily acquired this micromill recently to learn CnC. Ran into a snag when the floppy disk drive is dead and i have no spares. Curious if anyone can tell me if its possible to get some updated programs/drivers for it? I believe it ran off DOS command line if i remember correctly. Here are some pictures.

Any direction would be very much appreciated.

Posted: **Mon 03 Jun , 2013 10:16 am**

I don't think this MicroMill has/had anything to do with Denford
Try here:
https://www.microproto.com/

Posted: **Mon 03 Jun , 2013 15:16 pm**

HAHA wow yes thank you very much! Pulled up a ton of google searches, seems i entered this in the wrong forum.

Denford Software & Machines

Hello new owner of an older micromill 2000

Hello new owner of an older micromill 2000

Re: Hello new owner of an older micromill 2000

Re: Hello new owner of an older micromill 2000