Page 1 of 1
Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5
Posted: Tue 18 Dec , 2012 20:53 pm
by johnsonp3
Can you help me identify my machine, and tellme what drivers and software it came with?
Micromill 2000
Ser. # 57598
Denmint v2.0/S/B19-JD5
thanx
paul johnson
Re: Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5
Posted: Wed 19 Dec , 2012 14:37 pm
by Denford Admin
It will have run from VR Milling version 2.xx
This is the inspection document but doesn't tell you much more.
Re: Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5
Posted: Wed 19 Dec , 2012 21:14 pm
by Martin
It looks as if it will have been shipped with VRMilling Version 2 software.
Re: Micromill 2000; Ser. # 57598 ; Denmint v2.0/S/B19-JD5
Posted: Wed 19 Dec , 2012 21:35 pm
by Steve
It should say on the serial number label on the side of the machine.
The EPROM will work with VR Milling 2 or 5