Denford Software & Machines

I cannot find a set of wiring diagrams that match the MicroMill 2000 I have.
Would someone point me in the right direction......

Thanks in advance,
Orin

Here are photos of the data plate, electronics panel, and close-ups of the 5 relays and controller.
Speed controller appears to be a KB Electronics.

Are the attached drawings the ones I should use for my MicroMill 2000?
It appears that collectively they would be correct for my machine.

These drawings are from file MicroTurn-Electrical-Denstep-110v-circa2000.pdf which I found at:
viewtopic.php?f=36&t=2929

Based on other Denford drawing sets numbering sequence I've looked at, the drawings missing are MK2-1, MK2-2, and MK2-4
and drawings MT-2000-1, MT-2000-2, and MT-2000-4 could be used to replace the missing drawings.

Orin

Use the Micromill 2000 Denstep drawings from the attached link:

viewtopic.php?f=36&t=2929

Steve wrote:Use the Micromill 2000 Denstep drawings from the attached link:

viewtopic.php?f=36&t=2929

Please take a look at the photos of the electronics panel in my MicroMill 2000.
Note that there are 5 relays, not 3 as in the drawings you recommended and that the spindle speed is controlled from the DenStep and not from the front panel mounted pot.

Sorry but I can't find any drawings which match your machine...it could be a development or test machine which would have been documented in the USA office (now closed)
I've added all I could find to this post:
viewtopic.php?f=36&t=2929

Thank you very much for posting the drawings.
The drawing series M2K-AU xx in file Micromill-2000-denstep-110v-1.pdf appears at first glance to be correct for my machine.

Orin