Page 1 of 1
Micromill directional control.
Posted: Thu 13 Oct , 2011 16:16 pm
by Jeff_HATC
I upgraded my micromill VR Milling software to version 2.3.
Since then it will not let me jog any two axis at the same time with the computer keyboard.
It used to jog x and y together if you pressed both buttons.
Anyone know how to fix this?
Re: Micromill directional control.
Posted: Thu 13 Oct , 2011 18:43 pm
by Martin
I don't think you have ever being able to jog more than 1 axis at a time in either VRMilling version 2 or 5.
Re: Micromill directional control.
Posted: Thu 13 Oct , 2011 20:04 pm
by Jeff_HATC
Hmm, maybe I am loosing it. It was 2006 last time I run it and I was sure I could then.
Are you saying this is just not possible.
Re: Micromill directional control.
Posted: Thu 13 Oct , 2011 20:14 pm
by Martin
I am sure Admin will confirm this in the morning.
Re: Micromill directional control.
Posted: Fri 14 Oct , 2011 8:39 am
by Denford Admin
I confirm none of the windows software has been able to manually jog two axes at once from the keyboard.
Maybe it was the DOS software that allowed you to ??
Re: Micromill directional control.
Posted: Fri 14 Oct , 2011 13:19 pm
by Jeff_HATC
OK. I guess we will drop that and consider it a memory lapse on my part
