Page 1 of 1
MicroMill and Control Keyboard
Posted: Thu 13 Oct , 2011 16:13 pm
by Jeff_HATC
We have a micromill 2000 that is run via serial port.
Can I use one of my denford "desktop tutor" control keyboards to run my micromill?
If so, how would I do this since the micro mill only has 1 serial port.
Re: MicroMill and Control Keyboard
Posted: Thu 13 Oct , 2011 18:41 pm
by Martin
The Micromill needs conecting to a computer via the serial lead. The desk top tutor can also be connected to the computer on a seperate serial port & will control the machine using dos based software.
Re: MicroMill and Control Keyboard
Posted: Thu 13 Oct , 2011 21:45 pm
by Jeff_HATC
Excellent. So I just need a system with 2 serial ports...com1 and com2, yes?
Then.... which software would I pick to run that tutor keyboard to be most compatiable with the micromill?
https://website.denford.ltd.uk/support/9 ... s-software