Micromill Comm Error

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
boots
CNC Expert
CNC Expert
Posts: 220
Joined: Tue 16 Jan , 2007 21:22 pm

Micromill Comm Error

Post by boots » Thu 15 Nov , 2007 16:27 pm

We have a Micromill with a communications error.

There is a “0” on the Denstep LED Display, according to the manual it is a “No comms board address fault”.

How do I correct this and get the machine up and running??????

Thanks for any help.
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 27 Nov , 2007 17:14 pm

is this a red or green seven segment display ?

I can't find 0 in the old denstep manual, but i can find small o (control in Offset mode)
Top
User avatar
boots
CNC Expert
CNC Expert
Posts: 220
Joined: Tue 16 Jan , 2007 21:22 pm

Post by boots » Tue 27 Nov , 2007 17:39 pm

The machine is up and running now.
The relays were unplugged and re-intstalled and the fuse on the control card was removed and reinstalled. Possible loose connection.

Red LED Display.

Micromill 2000 Machine Manual
Page 8.4 - Electronics
"The DenStep Control Board"
"LED Status and Fault Display"
Display "0" Meaning "No comms board address fault."
Top
Post Reply

Return to “Micromill / Microturn”