I have a Denford MicroRouter and love it so picked up a MicroMill 2000 when one came up and this is where my problem lies.
The router works perfectly but the Micromill will not connect.
It is the legacy Denstep board and i am running VR milling version 5. The cable is from my Router which works fine.
Here are a few pictures showing what settings i am using.
Any input would be appreciated.
Cheers
![Image](http://i423.photobucket.com/albums/pp311/DragyBaby/Proof/DA8A2AAC-4BA2-4C44-B124-95C732B0B35D_zpsfalrrree.jpg)
![Image](http://i423.photobucket.com/albums/pp311/DragyBaby/Proof/646E2704-DDE2-47F5-8F59-AFA0A0000269_zpsshro39re.jpg)
![Image](http://i423.photobucket.com/albums/pp311/DragyBaby/Proof/924B8683-DCF5-456E-8925-774ECCAB295E_zpsaxzplimp.jpg)
![Image](http://i423.photobucket.com/albums/pp311/DragyBaby/Proof/EAC8552B-64E5-4F29-9CB9-2EA5F6FF695C_zps0mrvxygh.jpg)
![Image](http://i423.photobucket.com/albums/pp311/DragyBaby/Proof/FA970B36-C4D9-4A6A-A992-326F1BBE1005_zps3b8gi2h4.jpg)