Hello new owner of an older micromill 2000

All info relating to the Denford MicroMill and MicroTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
avius
Posts: 2
Joined: Fri 31 May , 2013 4:14 am
Hardware/Software: micromill 200

Hello new owner of an older micromill 2000

Post by avius » Fri 31 May , 2013 4:27 am

I happily acquired this micromill recently to learn CnC. Ran into a snag when the floppy disk drive is dead and i have no spares. Curious if anyone can tell me if its possible to get some updated programs/drivers for it? I believe it ran off DOS command line if i remember correctly. Here are some pictures.

Image
Image
Image
Image

Any direction would be very much appreciated.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Hello new owner of an older micromill 2000

Post by Denford Admin » Mon 03 Jun , 2013 10:16 am

I don't think this MicroMill has/had anything to do with Denford
Try here:
https://www.microproto.com/
Top
avius
Posts: 2
Joined: Fri 31 May , 2013 4:14 am
Hardware/Software: micromill 200

Re: Hello new owner of an older micromill 2000

Post by avius » Mon 03 Jun , 2013 15:16 pm

HAHA wow yes thank you very much! Pulled up a ton of google searches, seems i entered this in the wrong forum.
Top
Post Reply

Return to “Micromill / Microturn”