I just thought this was amusing, the size difference.
Suitable caption anybody?
perhaps
"when I grow up I want to be an Easiturn"
or
"Demonstrating the varying machining tolerances at Denfords before QA"
umm, yes I am a bit cramped at the minute... and out of shot there's a 4ft square router I'm making and to operate the mill behind it I sit on router table
Does size matter?
Moderators: Martin, Steve, Mr Magoo
- Triac whizz
- CNC Expert
- Posts: 238
- Joined: Mon 17 Jul , 2006 21:48 pm
- Location: France
Does size matter?
- Attachments
-
- easiturn & orac.jpg (81.44 KiB) Viewed 3680 times
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
www.la-coterie.com
- Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
- Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact: