Hi all,
I was wondering if someone could help me. I recently acquired a Denford Easimill 1984 model which is missing all its stepper motors. I was wondering if someone could tell me what frame size the stepper motors are i.e. Nema 34 or 42? Also what holding torque they are? I have been looking on the forum but I cannot find a definitive answer.
I was also wondering if someone could tell me what pulley sizes and tooth number were fitted to the stepper motors.
Hope someone can help.
Many thanks,
Oliver
Easimill stepper motors?
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 9
- Joined: Fri 05 Dec , 2014 13:50 pm
- Hardware/Software: Triac PC with ATC, Easiturn3 on Mach3, Easimill, Orac lathe, Zeroturn Lathe
Re: Easimill stepper motors?
I have one of these machines. I am not using the original controller as it was U/S upon arrival even though mechanics were perfect.
I will try to get the stepper motor sizes and also the pulley toothed belt information for you later this week.
David Goadby
I will try to get the stepper motor sizes and also the pulley toothed belt information for you later this week.
David Goadby