X axis pulley removal?

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
nemo1966
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Wed 09 Oct , 2013 16:56 pm
Hardware/Software: None yet!

X axis pulley removal?

Post by nemo1966 » Sat 14 Dec , 2013 18:14 pm

Hi trying to eliminate a bit of backlash on the x axis, i got to the pulley driven by the stepper belt and removed the two small grub screws that are approx 90 degrees apart. I cant find any grubs screws under those but the pulley will not budge. Am i missing something? If not any tips for removing it?

The bearing feels a little rough as well, can anyone recommend a replacement should I need it?

Thanks
Steve

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: X axis pulley removal?

Post by Martin » Sun 15 Dec , 2013 0:10 am

Can you post a photo?

Multispool
Posts: 22
Joined: Mon 04 Aug , 2008 11:28 am

Re: X axis pulley removal?

Post by Multispool » Thu 19 Dec , 2013 21:33 pm

Yea a photo would help!

The bearings probably remained standard, On my Easiturn3 they are part no's BI 00190 two sets(of two) required for the drive end, and BI 00110 B (2) req the tailstock end.
Early Denford metric manual Mill
Retrofitted Triac
Easiturn-3

nemo1966
CNC Apprentice
CNC Apprentice
Posts: 38
Joined: Wed 09 Oct , 2013 16:56 pm
Hardware/Software: None yet!

Re: X axis pulley removal?

Post by nemo1966 » Fri 27 Dec , 2013 18:02 pm

Thanks it was just a bit corroded on. Made up a pulling jig and got it off.

Post Reply