Loading metric programs to a pnc2
Posted: Wed 24 Apr , 2013 16:26 pm
Does anyone know how to load a metric program into an easyturn3 lathe with a pnc2 control via the serial port (rs232)
I have tried putting FC (Function metriC) at the start of the program but this generates the
same error message as the first XZ move (target position is outside table limit)
if I type a program directly into the machine setting metric units first then it will run as a
metric program so M/C will accept metric units
any help would be gratefully received
jmini
I have tried putting FC (Function metriC) at the start of the program but this generates the
same error message as the first XZ move (target position is outside table limit)
if I type a program directly into the machine setting metric units first then it will run as a
metric program so M/C will accept metric units
any help would be gratefully received
jmini