silly question

jpmiller · Post by **jpmiller** » Thu 03 Nov , 2011 0:12 am

where does this go? tool holder i removed the compound slide but hole's don't line up

https://i60.photobucket.com/albums/h25/s ... s/0242.jpg

https://i60.photobucket.com/albums/h25/s ... s/0212.jpg

https://i60.photobucket.com/albums/h25/s ... os/021.jpg

angel-tech · Post by **angel-tech** » Thu 03 Nov , 2011 12:18 pm

that looks like a rear toolpost

jpmiller · Post by **jpmiller** » Thu 03 Nov , 2011 13:59 pm

I sort of thought it might be a rear one,but unsure as to
Where to attach on the rear as there are no mounting
Holes on rear of crosslide lathe was a pnc2.

Thanks scotty

angel-tech · Post by **angel-tech** » Thu 03 Nov , 2011 14:15 pm

normally on the backend of the cross slide, take the blue cover off at the back of the cross slide and have a nose.

jpmiller · Post by **jpmiller** » Thu 03 Nov , 2011 19:52 pm

Ok I had a wee look tonight but no joy

here is a few more pic's

https://i60.photobucket.com/albums/h25/s ... os/018.jpg

https://i60.photobucket.com/albums/h25/s ... os/017.jpg

https://i60.photobucket.com/albums/h25/s ... os/016.jpg

regards scotty

angel-tech · Post by **angel-tech** » Thu 03 Nov , 2011 23:01 pm

there doesn't look like there's a place for it.

Denford Software & Machines

Denford Software & Machines

silly question

silly question

Re: silly question

Re: silly question

Re: silly question

Re: silly question

Re: silly question