Page 1 of 1
easymill 3 z axis fail ( red light )
Posted: Wed 01 Sep , 2010 14:24 pm
by cncbasher
have an easymill 3 showing the 2nd red light down on the z axis digiplan driver , i have swapped the driver for the y axis and the fault still shows on the z axis , so must be on the machine somewhere , any pointers please anyone .
thanks all
Re: easymill 3 x axis fail ( red light )
Posted: Wed 01 Sep , 2010 15:44 pm
by Denford Admin
Have you got the digiplan manual ?
eg:
9.6 Axis Card LED 1
Illumination of this LED indicates a short circuit across the two
motor terminals.
9.7 Axis Card LED 2
Illumination of this LED indicates that excessive continuous current
has been detected, and the drive has folded back. See Section 8.2 for
details of the options relating to this feature.
Find out now if it's in the wiring or motor by swapping the motors
Re: easymill 3 z axis fail ( red light )
Posted: Wed 01 Sep , 2010 15:48 pm
by cncbasher
sorry no do not have the digiplan manual , thanks will check the motor
regards
Dave
Re: easymill 3 z axis fail ( red light )
Posted: Wed 01 Sep , 2010 16:35 pm
by Martin
There are also a couple of fuses & LED's on the card that the CD20 drives plug in to.
Re: easymill 3 z axis fail ( red light )
Posted: Wed 01 Sep , 2010 16:43 pm
by Denford Admin
If it is CD20 then the manuals are here:
viewtopic.php?f=15&t=561&hilit=parker
I was qouting from a Parker Digiplan HFC DC servo drive manual, so it's probably duff info