Denford Software & Machines

Posted: **Sun 31 Aug , 2008 20:52 pm**

Sorry to ask this question and probably seems petty lame to some of you, but just finding my feet with a denford Easiturn.

Is it normal for all the programs and tool info etc... get wiped out of the control when powering down?

Adee

Posted: **Fri 05 Sep , 2008 12:41 pm**

Yup!

I just switch the lathe off and leave the controller on. I think I'll add a UPS for the controller as we had a power cut yesterday and it lost everything! Not a big problem - but it took a while to set all the tool offsets.

Si

Denford Software & Machines

Newbie question, loss of info when powering down?

Newbie question, loss of info when powering down?