Newbie question, loss of info when powering down?

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
Adee
CNC Apprentice
CNC Apprentice
Posts: 43
Joined: Tue 19 Aug , 2008 8:48 am
Location: Hampshire UK
Contact:
Contact Adee

Newbie question, loss of info when powering down?

Post by Adee » Sun 31 Aug , 2008 20:52 pm

Sorry to ask this question and probably seems petty lame to some of you, but just finding my feet with a denford Easiturn.

Is it normal for all the programs and tool info etc... get wiped out of the control when powering down?

Adee
Top
SimonRafferty
CNC Expert
CNC Expert
Posts: 102
Joined: Tue 12 Aug , 2008 15:53 pm
Hardware/Software: Denford Cyclone P
EMCO PC Mill 100
Solidworks 2018
SimSolid
Location: Horsham, UK
Contact:
Contact SimonRafferty

Post by SimonRafferty » Fri 05 Sep , 2008 12:41 pm

Yup!

I just switch the lathe off and leave the controller on. I think I'll add a UPS for the controller as we had a power cut yesterday and it lost everything! Not a big problem - but it took a while to set all the tool offsets.

Si
Top
Post Reply

Return to “EasiMill / EasiTurn”