How do I conect to an Easturn 3 with PNC3 control ?

bradders · Post by **bradders** » Fri 22 Aug , 2008 9:38 am

bradders · Post by **bradders** » Fri 22 Aug , 2008 9:49 am

This is the only drawing we have for a IBM to PNC3 control cable

See this thread for Easiturn manual
viewtopic.php?t=1682&highlight=pnc3

SimonRafferty · Post by **SimonRafferty** » Fri 29 Aug , 2008 10:05 am

On mine, it had a din socket on the back, but the wiring did not match any of the diagrams I'd seen. Inside the case there are three wires connecting to the socket. Black, Red and Blue. Black was the ground, Red and Blue the Tx & Rx (may be the other way round).

I just soldered them on to a D9 connector and put that on the back instead - now any old serial lead will work.

If I remember, I'll give you the colour to D9 connections

Si

Denford Software & Machines

Denford Software & Machines

How do I conect to an Easturn 3 with PNC3 control ?

How do I conect to an Easturn 3 with PNC3 control ?