Page 1 of 1
Easimill PNC Sensors
Posted: Thu 05 Jul , 2007 13:58 pm
by bradders
Does anyone know the sensor details for Easimill PNC axis sensors, NPN or PNP, 2 or 3 wire, Voltage etc
Posted: Thu 05 Jul , 2007 18:43 pm
by Triac whizz
I can give you a starter for 10 - they're 2 wire if the Easiturn is anything to go by...
I'll have a look see if I've still got the original ones...
Posted: Thu 05 Jul , 2007 18:59 pm
by Triac whizz
You're in luck! I found one and stuck it on my RS proximity switch tester and it seems to indicate that it's PNP (assuming I connected the 2 wires in the right place
(I'm not an electronics guru but I know what an electrolictic capacitor looks like - even if I can't spell it
)
Voltage? dunno but it works with the RS thingy which uses 9v....
any use?
Posted: Fri 06 Jul , 2007 7:23 am
by bradders
Cheers Triac Whizz, after a lot of searching I found some in stock (BI00401A) and you are right they are 2 wire devices
Posted: Fri 06 Jul , 2007 22:16 pm
by Triac whizz
Cheers Traic Whizz
No worries, i see you have one of those dsylexic keyboards
Good job you didn't print the stickers for the machines
you can call me TW
Posted: Mon 09 Jul , 2007 7:11 am
by bradders
Fridays ! What can i say ?