easiturn 3 micro cassette

All info relating to the Denford EasiMill and EasiTurn lathes and mills

Moderators: Martin, Steve, Mr Magoo

Post Reply
techy
Posts: 30
Joined: Mon 12 May , 2008 14:00 pm

easiturn 3 micro cassette

Post by techy » Tue 11 Nov , 2008 20:45 pm

can anyoe help with a solution to the lack of suitable micro cassettes for this m/c. i am thinking that maybe, just maybe the cassette mechanism from a cheap dictaphone machine could be used to interface with the existing unit, tapes for these are readily and cheaply available [i am thinking back to when the spectrum 48k (circa 1983) stored and loaded programmes from a standard tape deck]
Top
User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Wed 12 Nov , 2008 9:55 am

Hi, If you don't have any luck with cassettes, have a look at downloading programs from a PC, these previous threads should help:

viewtopic.php?t=150
viewtopic.php?t=421
Top
Post Reply

Return to “EasiMill / EasiTurn”