I am in the process of converting a 1985 415v 3 phase belt drive head Easimill and I would like to know if the spindle motors supplied with those machines was dual-voltage, as it's my intention to drive it via an inverter.
TIA,
H.
EASIMILL SPINDLE MOTOR.
Moderators: Martin, Steve, Mr Magoo
-
angel-tech
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: EASIMILL SPINDLE MOTOR.
you may find that it already has an inverter fitted which is run from single phase 240v. Look for a KEB Combivert 52
Re: EASIMILL SPINDLE MOTOR.
No, no inverter fitted to this belt drive head machine. I suppose all speed changes were done manually.
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: EASIMILL SPINDLE MOTOR.
I'm sure the manual (original) version of this machine had some info...think it was a Senior 3c or something like that.