Harrison Tu150/Cyclone with Fanuc OT-A with Fusion 360
Posted: Sun 18 Feb , 2024 11:01 am
Hi All,
I am at my wits end. I'm struggling to get my "new to me", Harrison/Cyclone cutting correctly with my fusion 360 post processor. It is as if the X axis is reversed on the machine and I have no clue how to fix it. When I run a program, it cuts the part as if the tool post is by the operator and not away from the operator. Does any body have any tips. Its frustrating me so much. Does anybody have a Fanuc OT-a manual as well as parameter manuals.
Regards
Graeme
I am at my wits end. I'm struggling to get my "new to me", Harrison/Cyclone cutting correctly with my fusion 360 post processor. It is as if the X axis is reversed on the machine and I have no clue how to fix it. When I run a program, it cuts the part as if the tool post is by the operator and not away from the operator. Does any body have any tips. Its frustrating me so much. Does anybody have a Fanuc OT-a manual as well as parameter manuals.
Regards
Graeme