Alphacam post for Denford Cyclone

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
Bolan41
Posts: 12
Joined: Mon 29 Aug , 2022 10:31 am
Hardware/Software: Denford Cyclone/Alphacam

Alphacam post for Denford Cyclone

Post by Bolan41 » Mon 29 Aug , 2022 19:29 pm

Hi all does anyone know if there is a Alphacam post for for a Cyclone lathe. I have just purchased this machine so all a bit new to me mostly ese cnc routers. Thanks
Attachments
cyclone lathe plate.jpg
cyclone lathe plate.jpg (124.91 KiB) Viewed 4332 times
cyclone lathe.jpg
cyclone lathe.jpg (101.13 KiB) Viewed 4332 times

User avatar
rasp
CNC Expert
CNC Expert
Posts: 123
Joined: Wed 06 Feb , 2008 18:33 pm

Re: Alphacam post for Denford Cyclone

Post by rasp » Wed 31 Aug , 2022 1:35 am

The Fanuc 15,18 or 21 post should work fine.

Bolan41
Posts: 12
Joined: Mon 29 Aug , 2022 10:31 am
Hardware/Software: Denford Cyclone/Alphacam

Re: Alphacam post for Denford Cyclone

Post by Bolan41 » Sat 03 Sep , 2022 6:36 am

Hi thanks for the reply, what about the 6Tpost would that work?

User avatar
rasp
CNC Expert
CNC Expert
Posts: 123
Joined: Wed 06 Feb , 2008 18:33 pm

Re: Alphacam post for Denford Cyclone

Post by rasp » Sun 18 Sep , 2022 17:34 pm

I will work as long as you do not use the canned cycles in Alphacam, The 6T post is single line canned cycles, the 0i,15 18i and 21i are all 2 line canned cycles unless you have the F15 option installed in the control.

Post Reply