spindle alignment
Posted: Sun 26 Sep , 2021 13:37 pm
any tips or tricks?
my cyclone is cutting on a taper ,ie 24mm at chuck , 24.2 50mm out
it looks like there are m10 bolts holding the spindle body to the casting
allen bolts look fiddle to get to
so any tips for trying to get this to cut parallel
cheers
my cyclone is cutting on a taper ,ie 24mm at chuck , 24.2 50mm out
it looks like there are m10 bolts holding the spindle body to the casting
allen bolts look fiddle to get to
so any tips for trying to get this to cut parallel
cheers