CYCLONE POWER SUPPLY AGAIN.
Posted: Thu 09 Nov , 2006 18:08 pm
Does anyone have a manual and wiring diagram for a Denford cyclone with a seperate power supply (see earlier question) and fanuc control.
Denford Software & Machines
Welcome to the Denford CAD CAM CNC forum
https://www.denfordata.com/bb/
CYCLONE POWER SUPPLY AGAIN.
Page 1 of 1
Posted: Thu 09 Nov , 2006 18:49 pm
Please can you supply the serial number of the machine and the date supplied?
Posted: Fri 10 Nov , 2006 12:54 pm
serial number CY02020E Year of manufacture 1990
Posted: Mon 13 Nov , 2006 21:17 pm
Have a look at these..... 
(If you don't have anything that opens DWG, then try QuickCAM 2D - the Demo version will import DWG and DXF, but not let you print)
I presume being 1990, that its an OTA control ? These dwgs are a bit later than that, but should be quite close.
(If you don't have anything that opens DWG, then try QuickCAM 2D - the Demo version will import DWG and DXF, but not let you print)
I presume being 1990, that its an OTA control ? These dwgs are a bit later than that, but should be quite close.
Posted: Tue 14 Nov , 2006 17:45 pm
The machine is fitted with fanuc 21i-TA control
Posted: Tue 14 Nov , 2006 18:05 pm
If its a 21i, then it can't be a 1990 machine 
Here are the drawings anyway..
Here are the drawings anyway..
Posted: Thu 16 Nov , 2006 0:29 am
Had another look at machine. On the id plate for the lathe it has a serial number for the the electrical system. This being 9023675.