DENFORD CYCLONE POWER SUPPLY

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
g-speed
Posts: 22
Joined: Thu 02 Nov , 2006 17:49 pm

DENFORD CYCLONE POWER SUPPLY

Post by g-speed » Fri 03 Nov , 2006 18:24 pm

I HAVE LOOKED AT A DENFORD CYCLONE LATHE FOR SALE BUT I HAVE BEEN TOLD IT SHOULD HAVE A POWER SUPPLY BOX THAT YOU CONNECT TO 3-PHASE 415V AND THEN PLUGS INTO THE MACHINE WITH TWO BIG CONNECTORS APPROX 8 PINS EACH. WHAT DOES THIS BOX CONTAIN AND IS IT POSSIBLE TO OBTAIN A REPLACEMENT. THE MACHINE IS FITTED WITH FANUC CONTROL.
Top
User avatar
Triac whizz
CNC Expert
CNC Expert
Posts: 238
Joined: Mon 17 Jul , 2006 21:48 pm
Location: France

Post by Triac whizz » Sat 04 Nov , 2006 10:26 am

Probably all the expensive Fanuc cards and contactors etc - very expensive! The only use it will have will be a retrofit.
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
Top
Martin
CNC Guru
CNC Guru
Posts: 1916
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Post by Martin » Sat 04 Nov , 2006 18:25 pm

The box you are talking about should have a couple of transformers, a 24volt DC power supply & several fuses & circuit breakers. It was only the early machines that were built like that though. If the two 16 way plugs are fitted the transformer box is needed. It would be a trauma to reproduce the box now.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 06 Nov , 2006 0:48 am

Martin - isn't this box the Fanuc Autotransformer which provided 3 phase 200VAC to the drives and control ?
Top
Post Reply

Return to “Cyclone”