Page 1 of 1
Fanuc controller specification required
Posted: Wed 27 Apr , 2016 16:31 pm
by spannerman
Do you have any information or a copy of the manual for Cyclone no H01164/1 built 2001 with GE Fanuc 21i-T control. The manual supplied with my machine is not for this model. I have a servo error and need details of the Fanuc equipment installed on the machine.
Re: Fanuc controller specification required
Posted: Thu 28 Apr , 2016 9:55 am
by Martin
Cyclone 21i Manual
Re: Fanuc controller specification required
Posted: Thu 28 Apr , 2016 16:52 pm
by spannerman
Many thanks for the info but what I need is information to my specific machine. There is a servo fault requiring a replacement board. The service manual I have lists all of the Fanuc equipment and part numbers but its for the incorrect controller. The only way I can get over the problem is for the service guy to visit and take the controller apart to identify the board part number. Do you have a Fanuc equipment list for my machine?
Re: Fanuc controller specification required
Posted: Fri 29 Apr , 2016 10:53 am
by Martin
If you can supply the Fanuc 21i control serial number. I will have a look through what we have left.