Denford Software & Machines

HELP :
I am in need of the parameters for a Mitsubishi spindle inverter that is as fitted by the factory to my Denford Cyclone lathe (1992) if anyone could help me out with this info I would be extremely grateful
black8898

Hi - sorry for the late reply...we did have a look around here for any information, but unfortunately didn't come up with anything.
It seems as though this invertor was not used on many machines...it's possible you have the only one in fact

Thanks for the reply , what I have now done is to scrap the Mitsubishi drive unit as the company who have it for repair are struggling to find a new part required so I have decided to purchase a new drive unit , thanks for your help much appreciated
black8898