What is this ?

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

What is this ?

Post by Emimec » Mon 09 Feb , 2009 8:32 am

Any idea what this item is. It came with my Cyclone lathe
Attachments
IMG_2641 (WinCE).JPG
IMG_2641 (WinCE).JPG (9.51 KiB) Viewed 5561 times
IMG_2643a (WinCE).JPG
IMG_2643a (WinCE).JPG (4.59 KiB) Viewed 5561 times
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Mon 09 Feb , 2009 9:58 am

A dongle for this I think:
viewtopic.php?t=371
Top
Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

Post by Emimec » Tue 10 Feb , 2009 8:28 am

Many thanks. Of no use to me then !!!
Top
User avatar
Lone_Ranger
CNC Expert
CNC Expert
Posts: 221
Joined: Mon 01 Oct , 2007 15:23 pm
Contact:
Contact Lone_Ranger

Post by Lone_Ranger » Tue 10 Feb , 2009 19:12 pm

Emimec wrote:Many thanks. Of no use to me then !!!
Might be if the people you got the Lathe from still have the software!!

Always worth an "ask"???

Regards
Rob

:) :) :) :) :)

.
Top
User avatar
Denford Admin
Site Admin
Posts: 3649
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Wed 11 Feb , 2009 9:59 am

Always worth an "ask"???
I'd agree--it must have been good software at the time to warrant a dongle !
CNC machining (CAM) hasn't changed much over the years...the hardware and software has just got fancier.
Top
Emimec
CNC Expert
CNC Expert
Posts: 125
Joined: Tue 03 Feb , 2009 10:42 am
Location: North London

Post by Emimec » Sun 15 Feb , 2009 12:12 pm

The college do think they have it, but finding the sofware could be the difficult part !!
Top
Post Reply

Return to “Cyclone”