Drawing for bed

All info relating to the Denford Cyclone lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
mike2424
CNC Apprentice
CNC Apprentice
Posts: 42
Joined: Sun 25 Oct , 2015 18:30 pm
Hardware/Software: cyclone tu150e /fanuc

Drawing for bed

Post by mike2424 » Fri 30 Jul , 2021 14:16 pm

Hello all, I seem to remember somewhere on here where there were drawings with dimensions for things like the bed for a cyclone . I was going to try and fab one up and I was looking for that drawing for the dimensions. Any help would be greatly appreciated. Thanks Mike

mike2424
CNC Apprentice
CNC Apprentice
Posts: 42
Joined: Sun 25 Oct , 2015 18:30 pm
Hardware/Software: cyclone tu150e /fanuc

Re: Drawing for bed

Post by mike2424 » Sun 15 Aug , 2021 19:55 pm

I found it.

Max
Posts: 7
Joined: Tue 18 May , 2021 10:34 am
Hardware/Software: Cyclone

Re: Drawing for bed

Post by Max » Sun 22 Aug , 2021 15:09 pm

Hello,

Could you please post it via PDF?

mike2424
CNC Apprentice
CNC Apprentice
Posts: 42
Joined: Sun 25 Oct , 2015 18:30 pm
Hardware/Software: cyclone tu150e /fanuc

Re: Drawing for bed

Post by mike2424 » Tue 14 Sep , 2021 23:11 pm

I'm sorry I just did now notice this reply to my post, please forgive me for my tardiness. However I know I said bed but what I meant was the tail stock bed. And I did see that it's in the tail stock dimensional drawings. I hope I didn't keep you waiting unnecessarily. I am going to build the bed and the tail stock. I have a TU-150E, here in the States and it's been a struggle all along as nobody here has a clue. I have done everything I could trying to keep it original. I do need to make pictures and videos which I haven't, but I will. And then I will post them. Take care, Mike

Post Reply