Can not get it to do anything

All info relating to the Denford Compact 1000 and Compact 1000 Pro small routing machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
DDIGREGORIO
Posts: 1
Joined: Thu 18 Jan , 2018 17:18 pm
Hardware/Software: We are a high school just outside of Manhattan and have 2 of your products;
Microturn NS (U00706/3) and Compact 1000 (U00687/2).

Can not get it to do anything

Post by DDIGREGORIO » Thu 18 Jan , 2018 17:28 pm

We are a high school just outside of Manhattan and have 2 of your products;
Microturn NS (U00706/3) and Compact 1000 (U00687/2). I am new to this but very capable. This machines have been sitting idle for years - determined to make them useful to students. All software installed, connected but now get a fault message. "Machine Connection Problem" with red "could not connect to machine" - now I removed the side and plugged USB directly into the board connector - still nothing. Fuses look good. Any help would be much appreciated! Thanks in advance!
David Di Gregorio

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Can not get it to do anything

Post by Martin » Thu 18 Jan , 2018 21:04 pm

Have you installed the USB drivers?

Take a look in device manager. The drivers should be on the VRMilling CD's.

Post Reply