hi
The university has a triac vmc purchased in 1993, it hasnt been in comission for a while and i would like to get it working again. i dont have any of the manuals or software for the machine and i am learning how to use it from scratch. where can i get the software and is it possible to use a 2D or 3D modelling system such as mecsoft to generate the G-code?
will it be possible to connect a modern day PC such as an i5 or p4 to the rs232 port and run the equipment from there
thanks
triac vmc (1993) software
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: triac vmc (1993) software
Please post a photo of the inside of the electrical cabinet.