Techsoft 2D design on RM CC3 networks - WINEXEC FAILED
Moderators: Martin, Steve, Mr Magoo
-
Guest
Techsoft 2D design on RM CC3 networks - WINEXEC FAILED
I get the message “WINEXEC FAILED” when running Techsoft on a RM CC3 network
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
You Must tick legacy applications in the RM stuff - otherwise get winexec failed memory low error when trying to plot to Denford machines. This is because there are some 16-bit applications / DLLs
This error message may also appear when the InstallShield setup.exe program is executed over a network. Copy all the files on the distribution disk to a local folder and run setup.exe from this folder.
This error message may also appear when the InstallShield setup.exe program is executed over a network. Copy all the files on the distribution disk to a local folder and run setup.exe from this folder.