Hi there,
Ive inherited a Micromill and 2D Des V1.60 (Labelled as v2?). I have a CD Boxed, labelled as Denford Extension.
How to i install CNC Support for the Micromill? 2D Des doesnt give you the option to simply add a new mill, and when I install the Denford Extensions cd, it installs it to C:\Denford, but doesnt relate or talk to 2d des in anyway?
Any help would be appriciated
Adding Micromill Support to 2D Des v1.60
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3649
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Sorry for not answering sooner - your post seems to have been missed.
Techsoft v1.6 is (I think) the pre-release of Version 2
My version of "V2" is called v1.60 in Help -> About
This version is referred to on this forum as V2 and does not contain any support for CNC machines such as Denford or Boxford - only Roland and Graphtec.
Your only option is to get hold of version 1 Techsoft, or use the DXF import function in Version 5 VR Milling (if you have it)
- see this post:
viewtopic.php?t=267
Techsoft v1.6 is (I think) the pre-release of Version 2
My version of "V2" is called v1.60 in Help -> About
This version is referred to on this forum as V2 and does not contain any support for CNC machines such as Denford or Boxford - only Roland and Graphtec.
Your only option is to get hold of version 1 Techsoft, or use the DXF import function in Version 5 VR Milling (if you have it)
- see this post:
viewtopic.php?t=267