Cut file stopping
Posted: Mon 07 May , 2007 8:16 am
Hi
We are still getting going on our VR V5 Mill in Townsville as part of the F1 in schools challenge.
We have run NC files in the past - no problem, but now the NC file stops on the 14th line and the start button greys out.
By hitting stop go a few times I can get the program to start again but it only runs for about 10 more lines before feezing again.
There is no error message, the spindle keeps turning, but the router head does not move to new locations despite being further into the cutfile.
I would appreciate any ideas
Many thanks
Mike Clements
We are still getting going on our VR V5 Mill in Townsville as part of the F1 in schools challenge.
We have run NC files in the past - no problem, but now the NC file stops on the 14th line and the start button greys out.
By hitting stop go a few times I can get the program to start again but it only runs for about 10 more lines before feezing again.
There is no error message, the spindle keeps turning, but the router head does not move to new locations despite being further into the cutfile.
I would appreciate any ideas
Many thanks
Mike Clements
